Sym dd50 moped manual. SYM Scooter Parts 2019-01-29

Sym dd50 moped manual Rating: 4,2/10 379 reviews

SYM DD50

sym dd50 moped manual

Headlight Front winker light Remove front cover. Install clutch spring compressor onto the pulley assembly, and operate the compressor to let nut be installed more easily. Air cleaner clogged Engine speed can be Engine speed can not be 2. If handle turning is uneven and bending, stuck, or the handle can be operated in vertical direction, then adjust the handle top bearing by adjusting the steering nut. Installation: Install in reverse order of removal procedures. Use vacuum cleaner or other authorized tool instead. Screws Remove hook and 1 screw.

Next

SYM DD 50 Scooter Service Manual PDF Download

sym dd50 moped manual

Caution Do not bend the float arm. Please watch the following video for a quick overview of our business. Remove 4 screws from the front inner box. The connected circles with a line are that they should be in continuity. Piston Removal Place a clean rag onto crankshaft to cover the piston. Then, check for damage or other foreign materials attached. Ignition coil Measure the primary coil resistance.

Next

DD50

sym dd50 moped manual

Squeeze out remaining oil Squeeze oil out. Clutch ling broken motorcycle can not be driving 5. Wide open the throttle valve, and check if the calibration point aligns on the oil pump lever with the mark of pump body. Remove 2 bolts and then remove the air cleaner outer case. Caution Do not have pry out operation between cylinder and crankcase.

Next

Say Aloha to Hawaii's Favorite Moped

sym dd50 moped manual

Please visit our to see a complete list of all the useful Scooter Manuals we offer. Install the all removed parts. Connecting Rod Inspection Install bearing and piston pin onto connecting rod small end, and then check its clearance. If we can provide additional assistance of any kind please feel free to and tell us what you need. Check continuity on each switch.

Next

SYM DD50

sym dd50 moped manual

Caution Do not release the brake lever before the drain valve is closed. Never allow brake linings to be contaminated by oil or grease. Voltage regulator connector Inspection Probable cause Check voltage between battery terminal red and ground Blown fuse or poor main switch green. A motorcycle license is required and you must be at least 21 years old to rent a scooter. Check the valve seat for worn out or damage. Never run your engine in a closed Battery emits explosive gases; flame is area. Caution Mounting bolt Do not operate the brake lever after the clipper.

Next

Say Aloha to Hawaii's Favorite Moped

sym dd50 moped manual

Its sleek design makes for easy handling and 2-stroke engine gives the right amount of power for sightseeing Kauai. Caution Do not bend the reed valve stopper. Screw the right crankshaft puller onto crankshaft. Caution Improper headlight beam adjustment will make in coming driver dazzled or insufficient lighting for safety distance. Replace it if exceeds service limit.

Next

Sym Dd50 Moped

sym dd50 moped manual

Expect to see these colorful mopeds riding around the island. Remove needle clamp and fuel needle. Remove the pulse generator and alternator four 4 bolts, and then take out the alternator assembly. Right crankcase Crankshaft Removal Crankcase puller As the diagram show with 3 special bolts to install the crankcase puller onto the left crankcase. Remove the front under spoiler. Measure the outer diameter of drive face boss, and replace it if it exceed service limit. Driving pulley spring broken Engine can be started but 4.

Next

SYM DD 50 Scooter PDF Service/Shop Repair Manual Download!

sym dd50 moped manual

Remove all washes from the interfaces of cylinder head, cylinder and crankcase. Remove the spark plug cap from the spark plug section. Bolt Remove four bolts, and then take out the cooling fan. Lower level Cap plate Before the brake fluid reservoir is removed, turn the handle so that the brake fluid reservoir Diaphragm becomes horizontal, then remove the brake fluid Upper level. Screws Slide the side cover backward so that their hooks are out of slots.

Next

Sym Dd50 Moped

sym dd50 moped manual

Remove two bolts and then take out cooling fan cover. Remove 5 screws of the fuel filling cap. Remove the oil control cable from oil pump. Install driven pulley, drive belt, and left crankcase side cover. Remove master cylinder disc brake after 2 bolts removed. Caution Inhaling brake lining ashes may cause disorders of respiration system, therefore, never use compressed air or dry brush to clean brake parts.

Next