Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom's network services. Every installation can replace or credit at its option. If you are uncertain about the condition of your electrical appliances or household service, have a professional evaluate these units. The last two digits are programmed to indicate data transmission. It is possible for persons with criminal intent to develop techniques which reduce the effectiveness of these features. All authorized distributors and dealers have a warranty program.
Access to this protected area, without causing an alarm, will require that all partitions be disarmed. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. This section describes basic keypad commands. Line Grabbing Equipment This equipment is set up to carry out test calls at pre-determinedtimes. To bypass or unbypass a zone, enter the 2-digitzone number. For sections that require multiple 2 or 3 digit numbers, the keypad will double-beepafter each 2 or 3 digit entry and move to the next item in the list. The display will change accordingly.
It is only intended to alert you and — if included — your central station of an emergency situation. If a module has been removed, or if the slot assignment of a keypad has been changed, module supervision must be reset. It is designed to be connected to a compatible modular jack that is also compliant. Limited Warranty Digital Security Controls warrants the original purchaser that for a period of twelve months from the date of purchase, the product shall be free of defects in materials and workmanship under normal use. Any alarm system of any type may be compromised deliberately or may fail to operate as expected for a variety of reasons. When the system automatically terminates the Walk Test modes, it will annunciate with an audible warning 5 beeps every 10 seconds , beginning five minutes prior to the termination of the test.
All the keypads have an audible indicator and command entry keys. However, despite frequent testing, and due to, but not limited to, criminal tampering or electrical disruption, it is possible for this product to fail to perform as expected. The system will flash the Armed light to indicate that the system is armed with no entry delay. If the equipment is causing harm to the telephone network, the Telephone Company may request that you disconnect the equipment until the problem is solved. If the Command Output Code Required option is enabled, enter a valid user code. Delay Wireless Zn Cross Zn Silent Pulsed Zone Type: 00 Null Zone 01 Delay 1 02 Delay 2.
Power interruptions of any length are often accompanied by voltage fluctuations which may damage electronic equipment such as a security system. An appropriate disconnect device must be provided as part of the building installation. These limits are designed to provide reasonable protection against harmful interference in a residential installation. It can be removed, or it can be increased up to 45 seconds at the option of the end user by consulting with the Installer. Reporting codes are two digits and can use hexidecimal digits A through F.
This kind of keypad is often best used as a secondary keypad. Be sure to remove snow from exterior patio doors in winter; outdoor furniture or equipment should not block exits. For Future Use Wireless Zone Low Battery Delay: Number of days the system will delay reporting a wireless low battery to the central station. Carefully review the Family Escape Planning guidelines in this manual. Government Printing Office, Washington D.
However, there is no guarantee that interference will not occur in a particular installation. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Are all flammable liquids stored safely in closed containers in a well-venti-lated cool area? To arm the system in the Away mode, either press and hold the Away function button for 2 seconds or enter a valid user code and leave the premises through a door programmed as Delay. Bueno, por el momento no los molesto mas. This motion detector uses passive infrared to detect motion.
To do this remove the module from the Keybus and perform the Enable supervision function again See Section 2. All entries are disabled 9999 by default. This can be done using. To clear the Memory light, arm, then disarm the system. See installation instructions for details. The keys, however, will remain backlit.