Operation of the heated seat relay C1221 is controlled by the temperature sensor on a G wire. Master Lock Switch The master lock switch is a non-latching rocker switch mounted on the centre console, below the radio. In no way does Nayabfun. The tail door window will be disabled if any of the following occur: l The soft back is lowered. The motor will move the mirror upwards until the switch is released, or it reaches the end of its travel.
The remote audio controls contain a number of normally open switches and resistors. Fusible link 1 is connected in series with fusible link 2, which is also located in the engine compartment fuse box. For more information on brake lamp operation, refer to the Brake and Reverse Lamps section of this manual. The variable wipe potentiometer has 5 pre-set positions. This allows a battery feed from fusible link 12 of the engine compartment fuse box C0570 to flow through the relay C0212 and power the headlamp dipped beam bulbs as described previously.
The instrument pack incorporates a charge warning lamp which illuminates when there is no output or a low output from the alternator. The Res switch is a normally open, non-latching switch. For more information on the intermediate sensor, refer to the Automatic Gearbox — Jatco section of the System Description and Operation Workshop manual. If the brake fluid level drops below the recommended level, the switch contacts open. Fusible link 3 C0571 also provides a feed to the ignition switch C0028 on an N wire.
The window will now move downwards until the switch is released. The starter relay is located in the engine compartment fuse box, and is earthed C0576 on a B wire. The flasher unit is located in the passenger compartment fuse box and is earthed C0587 on a B wire. The vehicle will accelerate until the switch is released. The time displayed on the clock can be adjusted using the 'H' and 'M' buttons mounted in the clock bezel. The cruise control system uses mechanical, electrical and vacuum operated devices to maintain vehicle speed at a setting selected by the driver.
As current by-passes the resistor pack, the blower motor operates at high speed. The rear wiper will stop operating and return to its park position if any of the following occur: l The tail door is opened. The headlamps can be switched between full and dipped beam by pulling the column switch back against and past spring pressure. The cooling control unit C0208 is earthed on a B wire. Five door vehicles have a mid-range speaker mounted behind each front and rear door trim casing , in addition to high range speakers mounted behind the door mirror trim casings. When the lighting switch is turned to the side or headlamp position, current flows across the switch to fuse 16 of the passenger compartment fuse box C0587 on an R wire.
When the ignition switch is turned to the 'ignition' position, current flows across the switch C0028 to fuse 8 of the passenger compartment fuse box C0588 on a G wire. Charging The charging system comprises a battery and an alternator. For more information on audio system operation, refer to the relevant Audio System section of this manual. A speaker connected incorrectly will be out of phase with the remaining speakers, causing a deterioration of sound quality. Fuse 10 C0575 provides a constant battery feed to the inertia switch C0123 and the fuel pump relay C0730 on G wires.
Interface Unit Fuse 35 of the passenger compartment fuse box C0580 provides an ignition feed to the interface unit C1959 on a W wire. F17 10 A All Mirror switch. All are located within the engine compartment fuse box. If the temperature within the E-box reaches 35 ° C 95 ° F , the fan operates until the temperature drops to 27 ° C 80 ° F. A feed from fuse 9 of the engine compartment fuse box is now able to flow across the energised relay C0578 to the compressor clutch C0127 on an R wire.
The third control operates the four speed blower motor. Connectors should never be subjected to forced removal or refit, especially inter-board connectors. The motor will now power the sunroof back to the fully closed position. When the upper half of the switch is pressed and held, the sunroof will move to its tilt position. The energised main relay allows a battery feed to flow to fuse 4 of the engine compartment fuse box. The switch C0652 is earthed on a B wire.
The vehicle electrical system must be capable of supplying sufficient power to enable the engine to be cranked. Rear window operation can be controlled by the driver by pressing the rear window inhibit switch, which is also mounted on the centre console. The console mounted switch C0263 is earthed on a B wire. When the tail door is opened, the switch contacts close and an earth path is created on a B wire. Current flows across the switch back to the rotary coupler. F8 30 A All Blower relay. The vehicle electrical system must be capable of supplying sufficient power to enable the engine to be cranked.
All are located in the engine compartment fuse box. The rear fog lamps will only operate if; l The ignition switch is turned to the 'ignition' position. The window lift relay is located in the passenger compartment fuse box. The tail door window can also be lowered using the remote handset. The rear interior lamp can also be switched on and off manually, by pressing the switch mounted on the rear lamp assembly. This feed energises the reverse relay, which is earthed on a B wire.