This grid covers: Rear Hub Ref. This grid covers: Meter s Ref. To connect the right switch housing Black. Excessive clearances will cause the oil pressure at the crankshaft main journals to drop and lead to the damage of the bearing. The difference between the highest and lowest gauge readings is the amount of the effective stroke of clutch spring plate. Divide the original water hose 39062-0109 between the cylinder head and the radiator and insert the water pipe 39192-0011. Run the alternator lead from the inside of the cover as shown in the illustration.
Tachometer with Water Temperature Gauge 25031-1142 4. This grid covers: Fuel Injection Ref. This is done to start easily the engine with the second gear. The front pads are for higher braking force, and the rear pads are for higher braking force. Regulator Installation Use the kit alternator and the kit regulator 21066-0010 as a set. Fix the stator to the cover by the bolts.
The back-torque limiter operating condition can be changed by changing the total thickness of clutch plates and changing the number of leaf springs. Use the kit connecting rod assemblies 13251-0015. Plug 92066-1332 Plug 92066-1333 O-ring 92055-1262 Bolt 130G0625 312B0600 Calk the bolt for unplug the plug. Shift up Indicator Lamp 23016-0006 2. Install the cylinder head and adjust the camshaft chain timing.
First Edition 1 : Feb. Periodic Maintenance Chart The scheduled maintenance must be done in accordance with this chart to keep the motorcycle in good running condition. These kit parts quicken throttle response to the twist grip. To connect the right switch housing Black. To connect the shift up indicator Green.
Auto Shift Functions Be sure use the point type sensor. This grid covers: Radiator Ref. When changing the seat height, adjust the spring preload of the rear shock absorber. To connect the tachometer with water temperature gauge Black. This grid covers: B-14 Gear Change Mechanism Ref. When using the original connecting rod bolts, make recesses at both ends of the original connecting rod bolt to measure its length and determine the bolt stretch. Remove the related parts of the starter motor and insert the plugs to the hole of the starter motor inserted as shown in the illustration.
Main Harness with Original Meter and Kit Meter : 26031-0328 Sub Harness with Original Meter : 26031-0425 Sub Harness with Kit Meter : 26031-0426. To connect the inter face box Black. Fix the brackets 11054-0459 on the sub radiator by the bolts 130L0612. This grid covers: Engine Cover s Ref. If you adjust the valve timing, install the sprocket to the camshaft between the adjustable range of the long bolt holes.
Tighten the nut 1 to 59 N·m 6. Remove the three steel balls 600A0500 from the output shaft assembly. Select one of them in accordance with your race regulation. Oil Catch Tank: 52001-0002 Tank Capacity: Approximately 570 cc Oil Catch Tank Installation Install the mounting bracket 11054-0455 with regulator under the cross pipe of the frame by the bolts use the original regulator mounting bolts. This grid covers: Generator Ref. The kit connecting rod can use the original connecting rod bolt 92153-0491.
To connect the inter face box Black. To connect the original meter Black. Apply the engine oil to the tensioner rod, O-ring and tensioner body, insert them into the tensioner body. Kit piston has more reduced the weight compared the original piston. The back-torque limiter works to reduce the chance of rear wheel hop caused by engine braking during hard braking and down shifting. This grid covers: Valve s Ref.