If the indicator reaches the wear limit line, ask a Yamaha dealer to replace shoes as a set. Main switch The engine can be started only at this position and the headlights, taillight and meter lighting come on when the light switch is on. Rev the machine freely but do neutral. Otherwise your feet may con- Removing hands from handlebars or tact the rear wheels. Install the oil filler bolt.
Yamaha service repair manual with illustrations wiring diagram and photos in pdf format yamaha online technical manual site complete official service manual and repair manual for yamaha for professionals and do it yourself users yamaha yfm400 fwa400m 2000 bigbear kodiak atv service manual. To install Place the panel in the original position, and then install the bolts. Remove the tailpipe by pulling it out of the muffler. Never open the throttle suddenly. Do not touch the glass part of the bulb. Turn the adjusting nut on the brake pedal Brake pedal free play adjustment cable until the free play is 20—30 mm 1.
This adjust- tion b to decrease the engine speed. Could cause you to react more slowly. If it does not work smoothly, check for the cause. Bring the machine to a complete stop 1. Standard position: 2 To increase the spring preload, turn the ad- justing ring in direction a. Ask a Yamaha dealer to No compression.
Never go over the top of a hill at high speed. Put the tongue of sense and good judgment when carrying car- the loaded trailer on the scale with the go or towing a trailer. Remove the nuts from the wheel. When the needle reaches the ter. Instant download of the factory repair manual for the 2000-2002 Yamaha Kodiak 400 4x4 atv.
Move in direction b to turn off the starter choke. Install the front carrier by installing the carrier bolts, and then tighten them to the specified torque. Place the machine on a level surface. You name it and it's in here. Do not store the battery in an ex- cessively warm or cold place less than 0 °C 30 °F or more than 30 °C 90 °F.
If foam air filter oil is not available, cated more often if the machine is operated in engine oil may be used. The battery may discharge to the point that the starter motor will not operate properly. Remove the bolts at the bottom of the fenders. To prevent others might be likely to touch it. If any leakage is found, have a Yamaha deal- Antifreeze and water mixing ratio: er check the cooling system.
V-belt case drain plug 1. If neces- sary, adjust the brake light switch as follows. On extremely slippery surfaces, such as ice, go slowly and be very cautious in order to reduce the chance of skidding or sliding out of con- trol. Remove panels E and F. It is advisable to have a Yamaha dealer make this adjustment. You select lever into the forward position, and then should practice control of the throttle, brakes, release the parking brake. They should Beginners should get training from a certified then regularly practice the skills learned instructor.
Drive select lever box check hose 7-36. Learn to safely control skidding or sliding by prac- ticing at low speeds and on level, smooth terrain. This is the same type of service manual your local dealer will use when doing a repair. This did not help at all; it did not answer my initial question. Ride cau- tiously in unfamiliar areas.
Use the electric starter to see if there is compression. Because the engine is during this period, consult a Yamaha dealer. If necessary, apply 14 inches in depth. Make two measure- ments of the tire pressure and use the second reading. The chart below is printed only as a re- minder to you that the maintenance work is required. Look out for obstacles which could Improperly operating over obstacles.
Lubricate the inner cables and the cable ends. If any abnormality is noticed the following material. Pause a few seconds before the next attempt. Gas tank to carburetor hook up, carburetor clean out of gum, etc. Refer to this section each time a panel has to be removed or reinstalled. Tightening torque: Engine oil drain bolt: 23 Nm 2. Rear shock absorber assembly 14.